Posts by tweaky

Nearly new since I've used it only a couple times since I purchased it from Golfworks in 2005 for $90 . If you need a precision depth gauge for other than golf uses this is a good unit.    $50 shipped CONUS

each club's lie angle must be individually assessed and adjusted as there are inconsistencies in the bending of the shaft and the way you swing each club.  your fitter should have you swing each club either on a lie board or...

ks- are you in the Monterey area?  i notice your avatar is the 7th @ PB.  if so would you go to Palo Alto (the Golf Lab) to get her fitted? 

Coss- yer a time bomb tickin'.  i too am dealing with a bad back (two bad lower discs).  your decision is which is more important- your golf or your back and shoulder.  everybody will send you to various places trying...

what did you learn? you're going to buy another set off the rack or used from someone else?  the only difference will be in the head design.  the lengths will be the same (and may not be right for you), the lofts and lies may...

whatever you decide on your best bet is to find a clubfitter who can check and adjust them in loft and lie angles to be sure THAT part of them is correct for your swing.  what you SHOULD do to be sure you get clubs that work for...

all the parts were around $800, the rest is in the epoxy/ferrules/tools/my time.   all totaled- pricele$$

wtf is just a starting point, a guideline, and NOT intended to be THE perfect length.  it could very well be that YOUR perfect length for each club is 1" over what the wtf calls for.  it could very well be that YOUR perfect...

google Marius Filmalter before you decide,  50,000 putts analyzed says a lot.

get used to referring to "L" shafts as "Light" flex rather than "Ladies" flex.  Michelle Wie, Natalie Gulbis, et al are all ladies but i doubt they play with "Ladies" flex shafts.  the shaft flex is based on swing speed not...