or Connect
New Posts  All Forums:

Posts by tonycarnevale

Remember when they came stock with ys6 or ys+? dont you think your getting a better value out of that than something that a club manufacture paints? Does everyone on here work for club companies or....
I was just using the video as an example of what I was talking about. I was making my comments mainly off my own experience with drivers and shafts. 
 What about my question?
I came across this video on youtube. I play a Diamana whiteboard, which is an after market shaft. I can't believe how little effort is put into these made for shafts. It seems to me that there needs to be more industry regulations and standards.     I also heard that loft tolerances for Taylormade clubs is +/- 1.5 degrees. So a 9 degree driver is anywhere from 7.5-10.5 degrees. And a stiff shaft is anywhere better a regular and an x-stiff.  With this whats even...
I have the spinner shafts in my cg15 dsg 54, 58 and 62. I like them alot and definitely see a lower trajectory even with a softer feel. If you hit it high the ball won't suck back when it hits the green because it has run out of spin by the time it hits the green. I think this is the big difference. I notice a hair more check  with pitch shots from ~20 yards even. I definitely recommend them especially if you currently have a mis-match of wedges/ wedge shafts.
 ......
By the way good job taking your time to learn properly. Its really tough to make big swing changes once you have been playing a while. Check this out and you may be able to get a free lesson from your local PGA pro. http://www.playgolfamerica.com/index.cfm?action=flm      Hope this helps as well and best of luck! 
I just played a tourney actually at Portsmouth, is it semi-private or private?
Yes, he bumps to the left side. From the video above, even though you can't really break it down because theres not enough frames, it looks to me that he is opening his hips torwards the target before the club gets to the top. I don't see how your comment is relevent regarding the drill I thought would be helpful...
New Posts  All Forums: