• Announcements

    • iacas

      Create a Signature!   02/05/2016

      Everyone, go here and edit your signature this week: http://thesandtrap.com/settings/signature/.
Sign in to follow this  
Followers 0

Irons graphite shafts?

3 posts in this topic

What's the story on these?  Lots of comments on forged  v.cast, cavity v. muscle, all v blades  but little comment on shafts. I could use some betterment, esp on distance so am thinking of total change. Maybe cast, cavity and graphite. Any ideas?  Yeah, i read about steel over  graphite but probably too expensive for me if Kuchar uses them and Jack Nicklaus raves.


Share this post

Link to post
Share on other sites

Want to get rid of this advertisement? Sign up (or log in) today! It's free!

What's the story on these?  Lots of comments on forged  v.cast, cavity v. muscle, all v blades  but little comment on shafts. I could use some betterment, esp on distance so am thinking of total change. Maybe cast, cavity and graphite. Any ideas?  Yeah, i read about steel over  graphite but probably too expensive for me if Kuchar uses them and Jack Nicklaus raves.

You mean you want more distance?

I switched from PX 5.0 to AeroTech i95 (discussed in several other threads here). These are the composite shafts Kuchar plays that you mention above.

Feel better. Less stress on my elbows. NOT LONGER (at least not much if any). I was not looking for longer. The flight a bit higher. I really like them.


Share this post

Link to post
Share on other sites

I find graphite shafts to feel softer and easier on the joints and like them. I have heard a good bit of discussion about how much "softer" forged feels vs cast, but I presume that tends to be with the same shaft on both heads. I suspect cast may feel softer with graphite vs forged with steel. Graphite is often lighter than steel, so may add to distance by increasing swing speed somewhat (drivers all come with graphite for a reason). However, the lighter shafts will change the feel of the club as you swing it. This would at least take some getting used to if you have been using steel shafts. I suspect this difference turns a lot of steel shaft users off when they try graphites. I would suggest getting a good fitting and try both. See how the different shafts affect the launch monitor results and the feel of the clubs.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0

  • Want to join this community?

    We'd love to have you!

    Sign Up
  • 2016 TST Partners

    GAME Golf
    PING Golf
    Lowest Score Wins
  • Posts

    • Time to upgrade but ball but oh man!?
      You'll eventually want to plat a urethane ball.
    • My Swing (jbishop15)
      I see a lot of G-Mac in that swing! G-Mac has the same grip and also a shut face, maybe not as shut as you and DJ. If you would allow me to give my input. From what I can see you are the Tiger Woods of the backswing, no matter what you do or try to do you end up in a great position. I saw your first post and you were very inside going back, now you seem to be too outside. I'll leave the backswing to the others, my advice is to find somwhere between now and then. Since you're great at the top, try to find the most efficient path to the top, have your shoulders move from setup to top of backswing position in one smooth motion, without standing up on the way back. If you find the most efficient path with the arms you will find it somewhere in the middle, not too much in, not too much out, remember the swing is an arch, not straight lines, it's okay to get a little curvy with it. That's the best way I can explain in laymans terms. The reason you want to be efficient is to lessen the time of the swing. Most pros get the ball in the air in the time you take to get to the top. This is very common. The less time you take, the more repeatable it will be. Try to lay three balls next to each other, and rapid fire them. Do this a few times. Then hit one ball pretending you have to rapid fire three, but stop after one. This is a great drill. All this should help your backswing in no time!   Now I'm going to write what I think is a basic issue in your swing, which again has a lot of great positions in it. I strongly advise you work on the backswing first until you are so ewhat used to it (2 weeks) and then go onto this next part. You can have this next part in the back of your mind, allowing your body to toy with it without thought as you work on the backswing. Do yourself a big favor and DO NOT work on both at the same time. Remember the body learns better if it understands in the mind first, and then works on its own a bit, instead of trying to force feed new motions. From my experience the backswing part and this next part will take you a few months each to feel comfortable, but you will see the impacts very quickly. I think you will find solid contact if you choose to follow my advice.  Here is the next part: Your arms are swinging somewhat opposite of the direction of your body. This is a weight transfer issue. Golf instructors and books will have different opinions on how much weight you shoud have on your back foot on the backswing, some say 60% others say as much as 80%, some say 100%. I agree with the notion that you should have as much weight back as you can, without involving extra effort to go forward, like a rocking chair, it should be a load and release, not a pull and a push. In your swing your body is rocking back, but then it is leaning towards the target slightly, not much. The problem is your arms are swinging away from your body, completely on their own, there is little connection to the movement of the body. Then on the forward swing, your body begins falling back, and the arms begin swinging forward. Since you have the club face very shut, the body must also fall back to allow the club face time to square up, barring an insane hip turn. The result is at impact you are angled too much upward, the hands are pointing up and to the right, causing a high push, and more importantly adding loft to the club. This results in difficulty controlling distance, and shots that are weaker and higher than they can potentially be, given your natural power. So the fix here is to get the body and arms working more together. The first step is get that club face just a little less closed, maybe 5-10 degrees less, so that you don't have to strain yourself while not falling back. To do this just strenghten your left hand grip slighty, and try not to bow the left wrist as severely at the top. This is easier said than done, but once your clubface is more square/closed than closed/closed, it will allow some room for the body motion adjustment. The final step is getting the body to move forward with the arms, so you aren't falling back. You should notice a straighter left leg happening with this. There will be a lot less upper body tilt, and you will stay on top of your hips more. The hands forward part will have to wait until the body isn't falling back so severely, because part of the hands going forward is the body going left. You won't have a hard time with this because you already lag the club well. The best way you can get the body going in sequence going back and forward is to imagine throwing the club back as far as you can, and throwing the club forward as far as you can. If you have a lot of property and old clubs you can actually do this. The throwing the club forward part is practiced into nets by students frequently. The throwing back is important too. An impact bag will help as well. Remember if you wanted to throw a club far you would naturally put your weight into it, not against it, which is why the drill is so helpful. The only difference between throwing a club and the golf swing is two things. One you have to hold onto the club, for many reasons. Two* to get consistent contact you can't move laterally much off the ball. You want to feel as if you and the club are being pulled as hard as you can, without moving more than two or three inches off the ball, that is the real challenge. It's not easy to focus so much force while staying still, which is why the opposite weight transfer is a go to move for many golfers. Whatever it is, you must still use the same concepts as if you are throwing a club back and throwing a club upward, that is the best way for your mind and body will both understand where the ball is supposed to go. The last thing I will add is that when you imagine throwing the club, it does not have to be a straight line. The backswing throw should be up and behind you a bit, and the forward throw of course would be up and to your left a bit, since the swing is on an arch.  Hope you take this with you. :D
    • Irons, Irons, Irons!
      I agree on the lessons.  Learn to hit what you have now.  Once you understand the game a little better, you'll know what irons are best for you.
    • PGA Tour Caddies file class-action suit against PGA Tour for use of likeness, bibs
      "I like my chances at milking this case for an even greater amount of money, garnering me even more free publicity when it's discussed by the media! I will strongly advise my clients to write me another check." But seriously, if he's not surprised by the ruling why on earth would he like their chances to appeal the decision? If that was the expected outcome, what factors would make it more likely that they do well in an appellate court?
    • Different swing for Driver and Irons
      If that's the only difference I would say they have a lot more the same than not. Are the swings a golfer makes with a 5I and a 7I "the same"?
  • TST Blog Entries

  • Images

  • Today's Birthdays

  • Blog Entries