or Connect
TheSandTrap.com › Golf Forum › The Pro Shop › Clubs, Grips, Shafts, Fitting › Golf pride tour wraps install issues
New Posts  All Forums:Forum Nav:

Golf pride tour wraps install issues

post #1 of 3
Thread Starter 
I put golf pride tour wraps on my irons yesterday. They are the .60 ones. I checked them thus morning and I could twist the grip at the butt. Was very surprised. Used paint thinner and grip tape and put then on dynamic gold s300. Any ideas?
post #2 of 3
Did you turn the clubs upside down and tamp the butt end to make sure the grips got seated all the way on? If they're not fully installed, the butt end does not secure to the shaft.
post #3 of 3
Quote:
Originally Posted by Gripit View Post

Did you turn the clubs upside down and tamp the butt end to make sure the grips got seated all the way on? If they're not fully installed, the butt end does not secure to the shaft.

Speaking to this, I have a 3-wood that this happened to. I had it reshafted at a Golfsmith and they left the grip about 1/2" off of the shaft at the butt. I used compressed air (inserted through the hole at the end of the grip) to get the grip off and redo it myself. Over time though a lot of grips will end up twisted slightly after thousands of swings. I know that not one of my irons has a grip that is perfectly straight, but I do know that they all started out looking straight to my eye when I put them on.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Clubs, Grips, Shafts, Fitting
TheSandTrap.com › Golf Forum › The Pro Shop › Clubs, Grips, Shafts, Fitting › Golf pride tour wraps install issues