New to this forum so hi all!
I've played for a year now and always played with a poor set. I've just took over a set of TaylorMade RSi2's (4-Pw). As I'm 6'4 the clubs are 1 inch longer (once got measured at an open day somewhere and this is right for me).
So this is the setup with lengths:
Nr - std - plus1inch
i4 - 38,25 - 39,25
i5 - 37,75 - 38,75
i6 - 37,25 - 38,25
i7 - 36,75 - 37,75
i8 - 36,25 -36,25
i9 - 35,75 - 35,75
Pw - 35,5 - 36,5
I don't have the sets Aw (50) and Sw (56), but the standard length for those are:
Aw - 35,5 - 36,5 (same as Pw)
Sw - 35,25 - 36,25 I do have 2 Cleveland RTX3.0 wedges in 50 and 56. Standaard length for those:
50 wedge - 35,25
56 wedge - 35,125
These are not extended, and if I extend them with 1 inch they would become:
50 wedge - 36,25 (0,25 shorter than in the set)
56 wedge - 36,125 (a marginal 0,125 shorter than in the set)
I have searched/read a lot about lengthening clubs, but not necessarily about the extension of the wedges, and if the wedges also need to be extended (and match) with the iron set or not. Also because you sometimes grip the wedges shorter.
Also, anyone familiar with putting +1 inch on a RTX3.0? Is a wedge not normally more sensitive to changes in lie (as a result of the +1 in length)?
And, if I lengthen the 50 and 56, should I lengthen +1 inch, or match the length as if it were the clubs in the standard RSi2 set? (marginal difference though)
Would love to hear some of your opinions on this topic.
Greetings,
Hamerhaai (the Netherlands)