Jump to content
saevel25

What Type of Wood Is This?

31 posts / 1078 viewsLast Reply

Recommended Posts

31 minutes ago, dennyjones said:

No expert but it may be oak.

Oak has very open pours. Imagine millions of soda straws glued together and then sliced diagonally. 

I can't tell from your photos. Look at the wood closely and at an angle. Like this:P_Site-Finished-Flooring-Red-Oak.thumb.jpg.4ee0d094a59b5ce644ac7a1865136929.jpg

If it's oak, you'll see the open pours. 

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

8 minutes ago, boogielicious said:

Is there a non-stained side? Not oak. Could be cherry. These are cherry. Walnut is similar.

977C52A9-88C9-437F-AA46-96BE5292D5F7.jpeg

No, the back side is stained as well.

8B764F6E-A3EE-4170-B5B0-DAFEC40B8593.jpeg

here is a different angle.

4B85A08B-2D18-4675-BA25-A6DFABFF8E18.jpeg

 

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Changing my choice, going to The Father In Law for answer, he is a long time wood worker

 

Edited by djake

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

I was expecting Persimmon or some thing like that when I clicked the thread, but it does not look like a golf club.

I have no clue.

Edited by StuM

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Matt, check with a local cabinet maker.
The cabinets were most likely from a local supplier.
Most cabinets are made of Oak or Maple or even a higher priced wood when an owner specs a specific type.
Your pics look like Mahogany or Walnut.

Here are other Cabinet Wood Types:
Maple, Cherry, Knotty Alder, Red Oak, Hickory, Birch, Knotty Pine, Mahogany, Walnut, Clear Alder and Oak.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

46 minutes ago, Club Rat said:

Matt, check with a local cabinet maker.
The cabinets were most likely from a local supplier.
Most cabinets are made of Oak or Maple or even a higher priced wood when an owner specs a specific type.
Your pics look like Mahogany or Walnut.

Here are other Cabinet Wood Types:
Maple, Cherry, Knotty Alder, Red Oak, Hickory, Birch, Knotty Pine, Mahogany, Walnut, Clear Alder and Oak.

This is really good advice. 

As a long time woodworker and a guy who formerly owned his own custom cabinet business I can tell you I'm not sure. 

Here's why. Very often guys like me take cheaper woods and make them look like more premium wood. The best example I can think of is if you give me a pile of Birch, I can build you cabinets and tell you that they are Mahogany and you will never know that they aren't. 

Obviously nobody would ever confuse Maple with Oak or Pine with Ebony. But those are the far ends of the spectrum. A lot of cabinet grade lumber can be made to look very similar. 

Here are some tips. 

1 - Very often non-custom, but still high quality cabinets have a spec sticker on the bottom side of a drawer. Check for that first. If you find the spec or even the maker/product code, BOOM! You're done.  BTW - some manufactures put the sticker on the back of the drawer. 

2 - Check your sink base cabinet for a KCMA label. 

3 - Check the bottom of the wall cabinets or on an inside panel in the sink base cabinet. A lot of time the brand of the cabinet is marked there. Sometimes the color, door style, and construction of the cabinet will be there too. 

4 - If you end up getting just the brand name, you can get their catalog (either online or a real one) and try to match yours up. That's hit or miss, because a lot of times the maker will do just what I said and make a birch cabinet that looks like a mahogany or something of that ilk. But you may be able to figure it out. 

5 - If they are truly custom you will be able to tell because all of the faceplates between two cabinets will be seamless. Meaning the faceplates were put on after the cabinet boxes were installed. If your cabinets have those little lines between the doors or between the drawers than those cabinets were built in a factory or possibly a shop and installed, rather than boxes being custom built and facepates made on site. 

6 - If your cabinets are truly custom. Firstly, congratulations that's mighty rare. Secondly, you will have to contact the builder to find out who did the work. Unless they were like me and stamped (literally) their name and logo on the bottom of every drawer.

7 - If none of that works. You may have to cut into a piece. Fresh cut wood is far easier to identify. 

If you find this stamped on the bottom of the drawers, then I made them.

1644458552_chetscustom.thumb.jpg.131d9c731119a399fe3d8dec26e20374.jpg

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

6 minutes ago, ChetlovesMer said:

6 - If your cabinets are truly custom. Firstly, congratulations that's mighty rare. Secondly, you will have to contact the builder to find out who did the work. Unless they were like me and stamped (literally) their name and logo on the bottom of every drawer.

 

I think this is the case. The previous owner did mention that cabinets were Amish-made. I checked a few drawers and such, and there isn't any markings on them. The drawers are mostly high end plywood. The face of the cabinets look to be hardwood of some kind. There is some areas were the finish has rubbed off and you can see the grain underneath.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




  • Want to join this community?

    We'd love to have you!

    Sign Up
  • Support TST Affiliates

    SuperSpeed
    TourStriker PlaneMate
    Golfer's Journal
    Whoop
    FlightScope Mevo
    Use the code "iacas" for 10% off Mevo
  • Posts

    • 4i sounds about right for me. I don’t run into too many long holes like this, but by coincidence I played one yesterday. Hit a decent drive and had 4i in, made nGIR and ended up with bogey. I drive the ball poorly, though, so there are plenty of opportunities for me to hit 4i into greens even on short par 3s.
    • hi I’m having trouble hitting my irons either thinning it or chunking it  here’s a look at my swing and I would appreciate if you guys could tell me what I’m doing wrong im an 11 handicap and have been playing for 9 years   
    • Doesn't Pebble Beach have a bunker adjacent to the beach which is marked as a red PA (old water hazard)?
    • I swear that I was fit with 105 then when I picked up the clubs they had 120 in them. basically the srixon fitter couldn't really remember so they all just tiptoed around it and suggested that the 120s are right for me. Pretty shity really. And yeah also didn't put in extra length in the shafts based on my toe down swing at the time.  instead of just fitting me properly and letting me learn to swing the club properly.   Yes I like and agree with that advice good to hear thank you for your reply.
    • I can think of scenarios where a ball could be in both a penalty area and putting green (like an island green or something), but I'm struggling to think of a penalty area/bunker or bunker/putting green situation. Does anyone know of any examples of these in a well known course that I could google?
  • Today's Birthdays

    1. Darkfrog
      Darkfrog
      (43 years old)
    2. Jrock817
      Jrock817
      (40 years old)
    3. Leonclum
      Leonclum
      (48 years old)

×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.

The popup will be closed in 10 seconds...