Search the Community
Showing results for tags 'build'.
Found 2 results
Bought a new to me shaft pull Hzrdus black 6.5. Cleaned it all up and went to install the adapter and noticed there was alot of pressure. Got it installed and tried it out and it was like a steel rod. My average ss is 118 and I have a pretty aggressive transition. Pulled it off and tried to clean the tip out. Got 3.5 inches into the shaft and it was still solid?!? Did something change? Are shafts not hollow anymore? Dont want to dig further in and break something.
https://thesandtrap.com/b/training/build_your_own_8_x_8_indoor_putting_green_cheaply I wrote that awhile ago, and, well, that putting green "worked" just fine, but: It was small. It was "unfinished" looking. I mean, look… Anyway, I have a 12' x 7' piece of turf and a newly finished basement section begging for a little putting green on which I can work on things. Here's the area: The putting green (which has shelves on it to help flatten out some bumps and ridges from being rolled up) is 12' x 7'. The red area is about 12' x 5' (it's 7' if you go from the wall to the column). So, i could just lay the carpet there, frame the edges to make it look nice… and… have a perfectly flat green (roughly - I'm sure the floor has a tiny slant to it). But, I wouldn't have any holes to put to, and I wouldn't be able to change the break. That's what I want. In fact, my wish list includes: 1 to 3 holes. The ability to change the slant from being 0 to 4% either left-to-right or right-to-left. The first requires the entire putting surface to be at least about five inches off the ground. The cups are 4.25" deep. I have foam blocks I can get from @david_wedzik, but I could also just glue my grass to a board, or stretch it and not glue it, or just put glue in little spots to help hold it in place… I won't be chipping to the green, so the foam isn't a high priority. What I'd like help with is figuring out how to build something that will work as I need: to let me change the slope on at least one side (I could put the cups on opposite sides to get both breaks if only one edge can be lifted and support up to about 250 pounds without bending. Remember, though: it should either have something mechanical (like four screws, one in each corner? hydraulics seems like overkill…) to change the slope OR be light enough for me to change the slope. I also don't really care about lefty putters. @NatalieB and I are righties. Here's a mockup of the putting green itself: I added two grey holes at the bottom just as holes I could add eventually, if necessary. I might not even add them at first. Maybe if the carpet gets worn from standing in the same spot putting to the one hole? Anyway, sides B and D would need to be able to go up and down, and while on the 0-5% slope, to support the weight of a person walking on the thing. And they should be able to go up and down relatively easily. Eventually I would like to not have to go downstairs to change the slope for the kiddo. Beyond that… two "perks" would be nice: The edges: I probably don't want balls rolling off the edges, but I don't want something so high that it's going to interfere with many putting strokes. That means a 1" lip would suffice, really, above the green surface… but at the same time, it feels like 1" is enough to interfere with a putting stroke if the ball is only a foot or 15" away. If I put only one hole in, I could just have a bumper behind it, and keep the rest flush with the putting surface. If the edges had hardware to which you could attach things (like little metal spikes, for elevated string lines and the like), cool. If the edges are wood, that's pretty easily rigged up with a drill, though, so I'm not too worried about that. So, how would you do it? Help me get this done.