Help on a fitting issue of a set of irons I'm trying to buy!

[Rayy]

Hello all I'm from Venezuela, and I got a little problem of a set I'm trying to buy.

I don't have that much money to buy a new set of iron, so I'm looking for a used set. I want to get the mizuno mp 32 that I have try them, and I like them a lot, and it is easy to find then used and cheep.

I got fit from a pro on the golf course I play here in my country and he told me that I should get a 1/4 inch longer and 2 degree upright for this mizunos mp32. The problem is that I have been hard for me to find a used set of mp 32 with a 1/4 inch longer. I have only find standard!

Does 1/4 inch longer going to make a much difference on my shot that standard?

I can buy them standard and bent them two degree upright. Will that fit properly for me? or the 1/4 inch longer it's really going to make a differences?

Please help me on this one!

[glebert]

Extending clubs is very easy and cheap, and you could get that done at the same time you get the lie angle changed. It is just a steel tube that gets expoxied into the butt end of the shaft. I would have one club done first a little longer than !/4" over and you can grip down until you get the right length.

I've done my own extensions, and use an air compressor to blow the grips on and off, and I can then tune the length and not even waste grips.