I just fit a 0.355 shaft in a 0.370 hosel

[arturo28mx]

Just wanted to share. I had a wedge head with a 0.370 hosel and a True Temper XP 95 R300 shaft (wedge length). I measured the tip of the 0.355 shaft and after about an inch it becomes 0.370 parallel. So I just trimmed one inch off the tip and voila I now had a 0.370 shaft. I suppose that trimming one inch off the tip basically made the shaft "stiff" instead of "regular", but that's all right because it will go into a wedge. I epoxied the shaft into the head with no problem. I'm not saying all 0.355 shafts have this geometry, but for what it's worth these TT XP 95 shafts do have a true 0.370 parallel section above the taper. I don't feel comfortable using shims. This solution worked well for me.

 

[Typhoon92]

Hope it plays well he way you want it to.

[arturo28mx]

It's just a Gap Wedge. I don't think I need exact shaft specifications. If it were a 6, 7 or 8 iron I would be more cautious.