Specs on Burner driver shaft?

[scott71law]

Hi folks, I have a 2007 TaylorMade Burner driver with the shaft that came with the driver right from the factory, and I was wondering if anyone knew or had a link for info about the specs of the shaft(s) used for these drivers? It is a stiff flex, but that is all the info you can see on the shaft itself. I was wondering about the torque, kick pint, and any other relevant info. I am looking at duplicating ht especs for another driver I am 'putting together'. Thanks for any info.

Scott

[delav]

Hi folks, I have a 2007 TaylorMade Burner driver with the shaft that came with the driver right from the factory, and I was wondering if anyone knew or had a link for info about the specs of the shaft(s) used for these drivers? It is a stiff flex, but that is all the info you can see on the shaft itself. I was wondering about the torque, kick pint, and any other relevant info. I am looking at duplicating ht especs for another driver I am 'putting together'. Thanks for any info.

Without knowing for certain, I'd bet that it's a mid-low kickpoint shaft, with a higher torque rating (3.5+) and between 60-65g.

Most drivers intended for the general population of golfers tend to have shafts that promote high launch at the expense of accuracy and control found in a heavier, low-torque shaft.