Jump to content
Check out the Spin Axis Podcast! ×
Check out the Spin Axis Podcast!
IGNORED

Cutting shaft vs. Grip size

Mizuno Junky
 Share
Note: This thread is 5647 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

Mizuno Junky Established Member

Mizuno Junky

Posted
Posted
I'm getting my Ping G10 driver shaft cut down and was wondering if I should put in a slightly larger grip size than normal because of the shaft being cut from the butt end. Thanks guys!

TourSpoon Super Member

TourSpoon

Posted
Posted
How much are you cutting off? if it is an inch or less then probably not. If it is feeling borderline now then just throw an extra wrap of tape on. After you shorten the club, you will have to adjust for a reduced swingweight.

Callaway AI Smoke TD Max 10.5* | Cobra Big Tour 15.5* | Rad Tour 18.5* | Titleist U500 4i | T100 5-P | Vokey 50/8* F, 54/10* S,  58/10* S | Scotty Cameron Squareback 1


Mizuno Junky Established Member

Mizuno Junky

Posted
  • Author
Posted
Im cutting off about 1.25 inches to a 44'5 inch driver. Would i be using lead tape to adjust for the swingweight? Where do you apply it? Thanks

Note: This thread is 5647 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.

  I accept