Jump to content
Check out the Spin Axis Podcast! ×
IGNORED

play it as it lies?.....I don't think so


Note: This thread is 5396 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

Posted

Just got done golfing my home course.  It was super windy and wet.  On the ninth hole I hit a very low drive into the wind.  For some reason the 9th hole at my course seems to soak up water like none other.  My drive was headed right down the middle of the fairway.  When i get up to my ball i find that it is 3/4s buried into the fairway.  Not 3/4s like the top 1/4 of the ball is visible but the bottom half of the ball was covered and the 1/4 on top of the ball farthest away from where i would strike was covered.

There was no visible causual water and there was no ground under repair marking but i determined that this was rediculous and i took relieve with out penalty and just dropped behind this massive crater.

To give some reference to how far it was buried, when i went to grab it with my hand i could not get it out and i had to dig a little hole off to the side to get a hold of it.

Did i do this right?  Free relief?  And even if i was wrong i would not change how i handled that.  If i would have made an attempt to hit that ball all i would have done was bury it deeper into the ground.


Posted

sounds like you played it correctly:

Quote:
25-2. Embedded Ball

A ball embedded in its own pitch-mark in the ground in any closely mown area through the green may be lifted, cleaned and dropped, without penalty, as near as possible to the spot where it lay but not nearer the hole. The ball when dropped must first strike a part of the course through the green. "Closely mown area" means any area of the course, including paths through the rough, cut to fairway height or less.


Posted

My home course is over-watered pretty regularly. I've had to pull my drives out of more embedded lies than I care to count lol.

My Equipment:
Driver: 9.5* R9, 73g Fubuki stiff | 3wood: 15* R9 3 Wood, x-stiff shaft | Hybrid: 19* Lynx Hybrid, reg. flex | Irons: MP-68s (4i-PW), 5.5x flighted |
Wedges: 52.08*, 56.11*, & 60.07 Vokey Spin-Milled | Putter: Pixl L1.8, 33.5" | Balls: Pro V1x |


Note: This thread is 5396 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Want to join this community?

    We'd love to have you!

    Sign Up
  • TST Partners

    Carl's Place
    PlayBetter
    Golfer's Journal
    ShotScope
    The Stack System
    FitForGolf
    FlightScope Mevo

    Coupon Codes (save 10-20%): "IACAS" for Mevo/Stack/FitForGolf, "IACASPLUS" for Mevo+/Pro Package, and "THESANDTRAP" for ShotScope. 15% off TourStriker (no code).
  • Posts

    • I would think of it in terms of time. The time it takes to get the arm angle into a good position to deliver the club with proper shaft lean. Another component is rotation, but that is also a matter of timing. It relates to how the body stalls to give the golfer time to hit the ball. If you have to get 80+ degrees out of that right elbow in one third of a second versus 50 degrees in the same time then you have to steal time from somewhere. It is usually body rotation. That does not help with shaft lean.  I agree in that amateurs tend to make the swing more complicated than pro golfers. 
    • I haven't been able to practice like I wanted and won't for the next week.  1. The weather sucks in Ohio this year. I have been mostly inside hitting foam balls. Just kind of my basic stuff.  2. I woke up last Saturday with a left side rib muscle on fire. If I turned or leaned a certain way it would spasm that almost buckled my knees. I have been taking a break to let that settle. I don't want to get a long term injury. I think I pinched a nerve or just aggravated a muscles.   3. I am going on a mini-vacation to Florida (screw you Ohio weather) with a friend, and rolling that into a work conference I have next week. I will be with out my clubs for a week.  I will be back next in two Fridays to hit the ground running with some warmer temps and better weather in Ohio, hopefully. I would really like to get more out on the course and the range.     
    • Day 580 - 2026-05-04 Played eight holes. Sometimes golf kicks you in the nuts. 😉 
    • I work with a lot of golfers who want more shaft lean at impact, who currently have AoAs that range from +2° to -2°, and who love to see the handle lower and more "in front of their trail thigh" from face-on at P6. And a lot of these golfers try to solve the issue by working on the downswing. They do something to drag the handle forward. Or they just leave their right thigh farther back so the same handle location "looks" farther forward. Or they move the ball back in their stance. Or they push themselves down into the ground to get the handle lower and increase (decrease?) their AoA (to be more negative). The real fix is often to get wider in the backswing. To do LESS in the backswing. To hinge less, fold the trail arm less, abduct the trail arm less. I had a case of this over the weekend. Before, the player had 110° of trail elbow bend, "lifted" his trail humerus only a few degrees, etc. The club traveled quite a bit around him, and he tended to "pick" the ball from the fairways. In the "after" swings below (which are mild exaggerations — this golfer does not need to end up at < 70° of elbow bend. These were slower backswings with "hit it as hard as you normally would" intent downswings), you can see that he bent his elbow about 70° instead of 110° and lifted his right arm an extra ~15° or more. You can't see how much less this moved his hands across his chest (right arm abduction), but it was also decreased. His hands stayed more "in front of" his right shoulder rather than traveling "beside" them so much. The two swings look like this: The change at P6, without talking about the downswing one little bit (outside of him telling me that he tends to pick the ball), is remarkable: Without 110° of elbow bend to get out (which he gets to 80°, a loss of 30°), the golfer actually loses slightly less elbow bend (70 - 50 = 20), but delivers 30° less elbow bend, lowering the handle and letting the elbow get "in front of" the rib cage… because it never got "behind" or "beside" the rib cage. If you look at this video showing the before/afters of P6, you'll note the handle location (both vertically and horizontally) and the shoulders (the ball is in the same place in these frames). This golfer's path was largely unaffected (still pretty straight into the ball, < 3° path and often < 1.5°), but his AoA jumped to -5° ± 2°. I've always said, and in talking with other instructors they agree and feel similarly, that we spend a lot of time working on the backswing. This is another example of why.
    • We had a member of our senior club who developed a mental block on pulling the trigger. I played with him to see what the membership was talking about. I timed him a few times when he would get over the ball. 45 seconds. He knew he had a mental block and would chide himself, “Just hit it!” Once on the green he was okay and chipping was a bit better. It was painful to watch him struggle. Our “bandaid” was to put him in the last tournament  tee time with two understanding players. We should have suggested to him to take a break from our tournaments. I agree with the idea that when a player realizes they have a problem, the answer is to go fix it and not return until they are able to play at an acceptable pace.
×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.