Finding proper grip size?

[mrbillinoc]

Looking to re-grip my clubs and didn't know there was such a choice in sizes! I wear a Men's Cadet Small golf glove...should I be looking for an undersize grip...or even a ladies grip size?

Thanks!

[golfro]

hold your club infront of your as if you are about to take a swing. look at your left hand and see where your middle finger, ring finger lie. If there is a gap between your ring finger and your thumb pad, you may want to look into a smaller grip...likewise, if your ring finger or middle finger is digging into your thumb pad, you may look for something a grip that is a little bigger.

the ring finger and middle finger should slightly touch your thumb pad, but not dig into it.

[JWL1957]

There is no correct grip size. Some guys with large hands prefer thinner grips and some guys with smaller hands like thicker grips. I fit into a x large glove and still prefer a stock type thickness.

[erock9174]

not to highjack this thread but I have another grip related question.
If I cut my clubs down should I be using an Undersize grip to fit the cut down shaft properly?

[tws1098]

not to highjack this thread but I have another grip related question.

They are a different thckness on the outside, I don't believe the diameter of the hole in the grip is very different if at all for the different sizes because they are all fitting the same general size shafts.

[erock9174]

They are a different thckness on the outside, I don't believe the diameter of the hole in the grip is very different if at all for the different sizes because they are all fitting the same general size shafts.

Makes sense, Thanks

[Fatphil]

shafts have different thickness'. the Aldila graphite shaft in my driver is thinner than my steel irons, so the driver grip needs and extra wrap of tape to "feel" like my irons.