Jump to content
Check out the Spin Axis Podcast! ×
Check out the Spin Axis Podcast!
IGNORED

Driver Ball Position vs Driver Setup Position

Lambo

By Lambo
in Instruction and Playing Tips

 Share
Note: This thread is 4085 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

Lambo Member

Lambo

Posted
Posted
Hullo folks! Right. I have always struggled with a slice from my driver. The reasons for this have been vast and over the past few months my pro and I have been working hard on my swing (on all my clubs) to correct this. Faults have been chicken wing plus swinging out to in by 2 degrees with the chicken wing causing an open club face. These are almost completely fixed with the wing gone and swinging straighter through my irons. Now today at the range I managed to rid my slice with the big stick and actually started hitting draws and fades, both high and low, on command. Also this wasn't just to a massive field but setting myself targets for the width if a fairway with 80% of my shots going where I wanted them to go. Also I never just smash drivers all the time but change clubs at every shot. Now how did I do this? Well this is the big thing that I'm struggling with as it is "fundamentally" wrong. I setup as normal with my ball just on line with my big toe on my left foot (I'm a righty). Unfortunately, I also set up the driver in the middle of my stance like an 8 iron, and just swung at the ball with all my concentration on it. This felt very comfortable to me as spine tilt at a 'normal' address feels alien and I seem to bottom out far too early. Now, if I'm able to keep hitting good consistent shots like this, should I keep doing it? Or should I try and learn how to do it 'properly' and textbook? I was getting some funny looks with lads around me complimenting how well I hit it like that. Literally 200+ yards carry and I'm only 5"8 and 140 pounds. So. Should I keep doing it? Or is there a reason that I might be hitting it like this as there is a fault elsewhere that I haven't seen?

TimS65 Well Established Member

TimS65

Posted
Posted

Sounds like you're following this style:

This helped me too, though I now tee up behind the ball. But this was what cured my slice...

  • Upvote 1

Callaway Big Bertha V Series 10.5 Driver stiff shaft
Benross Hot Speed 16 deg 3 fw
Callaway XR 22 deg hybrid
Callaway XR 25 deg hybrid
Callaway Big Bertha 6-pw
Callaway Mack Daddy 3 48/54/60 wedges
Odyssey White Hot Pro Havok


  • Administrator
iacas Hall of Fame Member

iacas

Posted
  • Administrator
Posted

This video:

Comes from this thread:

Also, regarding ball position… in a single word: forward.

Erik J. Barzeski — ⛳ I knock a ball. It goes in a gopher hole. 🏌🏼‍♂️
Director of Instruction Golf Evolution • Owner, The Sand Trap .com • Author, Lowest Score Wins
Golf Digest "Best Young Teachers in America" 2016-17 & "Best in State" 2017-20 • WNY Section PGA Teacher of the Year 2019 :edel: :true_linkswear:

Check Out: New Topics | TST Blog | Golf Terms | Instructional Content | Analyzr | LSW | Instructional Droplets

Awards, Achievements, and Accolades
1
1
1
1
1
1
1
1

Lambo Member

Lambo

Posted
  • Author
Posted
Okay cool! Yeah that first video is exactly what I was doing without the extra tee. Sounds like its a winner even though it was just pure experimentation that I managed to do it. Thanks for the advice guys![@]TimS65[/@][@]iac[/@]

Note: This thread is 4085 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Want to join this community?

    We'd love to have you!

    Sign Up

  • TST Partners

    Carl's Place
    PlayBetter
    Golfer's Journal
    ShotScope
    The Stack System
    FitForGolf
    FlightScope Mevo

    Coupon Codes (save 10-20%): "IACAS" for Mevo/Stack/FitForGolf, "IACASPLUS" for Mevo+/Pro Package, and "THESANDTRAP" for ShotScope. 15% off TourStriker (no code).

  • Posts

    • saevel25
      LIFT Your Freakin' Arms

      By saevel25 · Posted

      Probably since the golfer has to swing the club back and up. The hands have to move back and up. You can feel them go back and up just by turning the shoulders and bending the right arm, because it brings your hands towards your right shoulder.  The difference is if you maintain width or not. Less width means a shorter feeling swing path so the more you need to lift the arms. Being as someone who gets the right arm bend at 110+ degrees, it's 100% a timing issue. I am use to like a 1.5+ second backswing. It probably should be like 1 second at most. Half a second or more will feel like an eternity. I have had swings where I keep my right arm straighter and I am still trying to time the downswing based on the old tempo.  Ideally, for me, it is probably going to be a much quicker and shorter (in duration) backswing, while keeping the right elbow straighter. Which also means more hinging to get swing length without over swinging. 
    • coachjimsc
      Wordle Daily Puzzle

      By coachjimsc · Posted

      Wordle 1,789 5/6 ⬜⬜⬜⬜⬜ ⬜⬜🟨⬜⬜ ⬜🟩⬜🟩🟩 ⬜🟩🟨🟩🟩 🟩🟩🟩🟩🟩
    • Ty_Webb
      LIFT Your Freakin' Arms

      By Ty_Webb · Posted

      I'm currently recuperating from surgery, so no golf, but have been thinking about this quite a bit. This and the don't overbend the right arm thing. It's hard for me to even pose the position, so I'm not 100% sure, but I feel like it's impossible to have the right humerus along the shirt seam and not overbend your right arm, unless your hands are down near your hips. If the left arm is up at or above the shoulder plane and your right arm is bent less than 90 degrees, then your right humerus has to raise or your hands will get pulled apart. Your left hand can't reach your right hand unless either the right upper arm is up or the right arm is overbent. Is that right? If it is, then focusing on not overbending the right arm would force you to raise the humerus. And actually thinking further on it, if you do overbend your right arm, then you're basically forcing your upper arm down or forcing your left arm to bend. Since (for me at least) bending the left arm too much is not something I think I need to worry about, it means that the bend in the trail arm is really the driving force behind what happens to the right humerus. 
    • Ty_Webb
      2026 TST Birdie Challenge

      By Ty_Webb · Posted

      I managed to knock off a 3, a 13, and a 15 a couple of weeks ago. The 3 was a 185 yard par 3 with a 6 iron to 12 feet. 13 was a 350 yard par 4, which was a 2 iron and a 9 iron to about a foot. 15 was a 560 yard par 5 with a driver in a bunker, 4 iron into the semi, gap wedge to 8 feet and a putt.
    • WillieT
      Wordle Daily Puzzle

      By WillieT · Posted

      Wordle 1,789 4/6* ⬜⬜⬜⬜⬜ ⬜⬜🟨⬜⬜ 🟨🟩⬜⬜🟩 🟩🟩🟩🟩🟩
×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.

  I accept