First Time Installing New Grips...

[WillieT]

Picked up a couple of Tommy Armour 845s Silver Scot wedges to complete my irons - a 52deg W3 (Gap) Wedge w/original TA grip and 56deg Sand Wedge w/jumbo Golf Pride Tour Wrap grip.  My other irons all have Golf Pride Tour Wrap grips standard size and I love them, so I picked up a couple of grips to change out the wedge grips.  The Gap wedge grip came off w/no problems and the rubber was literally breaking apart as I peeled it off.  Did find on the shaft the following lettering "DGIR 300 35".  Not sure what those numbers mean.   Applied the new tape and the Wedge Guys grip solvent.  New grip slid on just like the YouTube videos.  Woo hoo!  One down, one to go.  I was slightly torn about the Sand Wedge as this was a relatively new grip.  But the jumbo grip felt too fat in my hands, so out came the knife and off came the grip.  If I had been paying attention, I would have noticed that when the grip came off the tape underneath still had the outer paper on it....I could have just peeled it off, applied the solvent to the new grip and slid it on.  But no, I had to be overzealous and remove perfectly fine tape.  End of day, I have same grips on all the irons and life is good.  

[Vinsk]

I believe the shaft lettering is for Dynamic Gold R (regular flex) 300 and 35” long. 

[WillieT]

9 hours ago, Vinsk said:

I believe the shaft lettering is for Dynamic Gold R (regular flex) 300 and 35” long. 

Was thinking that it was that based on what I had researched on the web since posting.  From what I understand that’s good steel. Now that the wait is over it’s time to swing the clubs!