Jump to content
Check out the Spin Axis Podcast! ×
Check out the Spin Axis Podcast!
IGNORED

My Swing (jonasare)

jonasare

By jonasare
in Member Swings

 Share
Note: This thread is 6788 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

jonasare Newbie

jonasare

Posted
Posted

Do you see any obvious swingflaws or powerleaks?

Swingplane, shoulderturn etc?

My distance w the driver could fluctuate over 50 yds from week to week.

Driver...trying here to get a bit more left-chest-shoulder connection:

http://www.bestsharing.com/f/lLQbOtX345234

Good distance but really unconsistance and i aint looking at the ball in the backswing either!

Pw from behind - down the line:

http://www.bestsharing.com/f/BBWGfX7345238

9-iron sideview:

http://www.bestsharing.com/f/ofVDS345224

Advices needed reagarding getting more clubhead speed and consistant good distance!



Thanks


Fried Egg Established Member

Fried Egg

Posted
Posted
Looks pretty good, and must be if your a 4.

Try to keep your weight centered in the middle of your feet throughout the swing. This will help you stay in balance. If you look at your 9-iron down the line, in your backswing your head moves toward the ball. If you don't move back in the downswing, you will lose balance and fall towards the ball, which looks what happened in one of your driver swings. This should help with consistency. Unfortunately, it's not an easy fix. Keep using video.

Joe McNulty

5SK™ Director of Instruction, Cape Cod, MA

Driver - D3 9.5

3-Wood - SQ 15

Hybrid - 17 Adams

4-PW - 714 AP2

50, 56 & 60 - Vokeys

Putter - Scotty

Ball - Pro V1x


Finn07 Dedicated Member

Finn07

Posted
Posted
Maybe its just me but too difficult to watch the video, takes too long.
Driver-Taylor Made R7 460cc 10.5* Fujikara REAX Stiff
Fairway Wood-Taylor Made R7 Draw 15* Fujikara REAX Stiff
Hybrid Taylor Made 19* Rescue Mid Steel Stiff
4-PW-Golfsmith G40 TT Lite XL Stiff
GW-Ben Hogan Riviera 8* Bounce 50*SW-Ben Hogan Riviera Medium Bounce 56*LW-Cleveland 60* 588 ChromePutter-Taylo...

supercow Dedicated Member

supercow

Posted
Posted
- too much sliding (feel as though you maintain your knee flex in your back leg on the way back)
- bad balance (caused by bad setup, nothing you can really do about this except be more careful during your pre-shot routine)
- footwork is sloppy (notice how your both your left/right knee's both change knee flex in your driver swing?)
- swing plane seems a little steep (can't really tell though since you don't have a videos directly behind you)
- just swing the club (looks like you went for a little more hand/arm action during your first driver swing, second swing looks more synchronised)

Note: This thread is 6788 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Want to join this community?

    We'd love to have you!

    Sign Up

  • TST Partners

    Carl's Place
    PlayBetter
    Golfer's Journal
    ShotScope
    The Stack System
    FitForGolf
    FlightScope Mevo

    Coupon Codes (save 10-20%): "IACAS" for Mevo/Stack/FitForGolf, "IACASPLUS" for Mevo+/Pro Package, and "THESANDTRAP" for ShotScope. 15% off TourStriker (no code).

  • Posts

    • saevel25
      LIFT Your Freakin' Arms

      By saevel25 · Posted

      Probably since the golfer has to swing the club back and up. The hands have to move back and up. You can feel them go back and up just by turning the shoulders and bending the right arm, because it brings your hands towards your right shoulder.  The difference is if you maintain width or not. Less width means a shorter feeling swing path so the more you need to lift the arms. Being as someone who gets the right arm bend at 110+ degrees, it's 100% a timing issue. I am use to like a 1.5+ second backswing. It probably should be like 1 second at most. Half a second or more will feel like an eternity. I have had swings where I keep my right arm straighter and I am still trying to time the downswing based on the old tempo.  Ideally, for me, it is probably going to be a much quicker and shorter (in duration) backswing, while keeping the right elbow straighter. Which also means more hinging to get swing length without over swinging. 
    • coachjimsc
      Wordle Daily Puzzle

      By coachjimsc · Posted

      Wordle 1,789 5/6 ⬜⬜⬜⬜⬜ ⬜⬜🟨⬜⬜ ⬜🟩⬜🟩🟩 ⬜🟩🟨🟩🟩 🟩🟩🟩🟩🟩
    • Ty_Webb
      LIFT Your Freakin' Arms

      By Ty_Webb · Posted

      I'm currently recuperating from surgery, so no golf, but have been thinking about this quite a bit. This and the don't overbend the right arm thing. It's hard for me to even pose the position, so I'm not 100% sure, but I feel like it's impossible to have the right humerus along the shirt seam and not overbend your right arm, unless your hands are down near your hips. If the left arm is up at or above the shoulder plane and your right arm is bent less than 90 degrees, then your right humerus has to raise or your hands will get pulled apart. Your left hand can't reach your right hand unless either the right upper arm is up or the right arm is overbent. Is that right? If it is, then focusing on not overbending the right arm would force you to raise the humerus. And actually thinking further on it, if you do overbend your right arm, then you're basically forcing your upper arm down or forcing your left arm to bend. Since (for me at least) bending the left arm too much is not something I think I need to worry about, it means that the bend in the trail arm is really the driving force behind what happens to the right humerus. 
    • Ty_Webb
      2026 TST Birdie Challenge

      By Ty_Webb · Posted

      I managed to knock off a 3, a 13, and a 15 a couple of weeks ago. The 3 was a 185 yard par 3 with a 6 iron to 12 feet. 13 was a 350 yard par 4, which was a 2 iron and a 9 iron to about a foot. 15 was a 560 yard par 5 with a driver in a bunker, 4 iron into the semi, gap wedge to 8 feet and a putt.
    • WillieT
      Wordle Daily Puzzle

      By WillieT · Posted

      Wordle 1,789 4/6* ⬜⬜⬜⬜⬜ ⬜⬜🟨⬜⬜ 🟨🟩⬜⬜🟩 🟩🟩🟩🟩🟩
×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.

  I accept