Jump to content
IGNORED

TT XL Lite Shafts

neonlew

By neonlew,
in Clubs, Grips, Shafts, Fitting

 Share
Note: This thread is 6205 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

neonlew Well Established Member

neonlew

I have a set of eight TT Lite XL iron shafts which are R/S flex. What I am trying to do is tip trim them closer to an A-Flex. True Temper's instructions for an R-Flex say cut 2 inches off the tip for a #3 iron.

My question is would cutting off only 1 inch instead of the recommended 2 inches bring it near an A-Flex or should I cut off only 1/2 inch or 1 1/2 inches for the #3 iron? If so, then should I cut each higher numbered iron by the same amount (example: #4 iron cut only 1 1/2 inches instead of 2 1/2 inches and so on)?

I do not own a frequency analyzer machine to do it properly, so this is why I am asking this question.

Many thanks for your suggestions and/or input.

Lew
Link to comment
Share on other sites

Note: This thread is 6205 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.

  I accept
The popup will be closed in 10 seconds...