Jump to content
Check out the Spin Axis Podcast! ×
Note: This thread is 5418 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

Posted

Pulled the trigger and ordered Ping G15 irons.  I am second guessing my decision to go with the 4 iron through gap wedge (Ping labels as UW).  Anyone think I would be better off dropping the UW and getting a Ping Tour Wedge or perhaps Vokey or Cleveland for my 50 degree.


Posted

It really depends on how you use your gap wedge. I only use my G15 "U" for normal/full shots, no chipping/pitching. Of course it came with the set since I bought off the rack. I have a Callaway 54/15 that I use for sand and a Vokey 60/04 for chipping.  In my G10 set I really don't like the set SW and substitute a Ping Tour wedge.

What I would second guess is the 4 iron. I stop at a 5, of course my 5 irons are about the same loft as my Eye2 4 iron.

David


Posted

If you are going to carry four wedges, possibly you should do a gap analysis to see how well the wedges work together. Do you have any yardage gaps?

With Ping, Cleveland and Vokey wedges in play, shaft lengths might not match up for the wedges to work as a set . Could take some shaft trimming by clubsmith.

If you opt for CG14 GW, it may be difficult to find a 50.08 wedge in that model. Also, note that some CG14 wedges Tour groove (CC conforming) have been issued, and may not spin the same as original Zip Groove; CC versions have black rather than gold gel inserts on back of clubhead.

Focus, connect and follow through!

  • Completed KBS Education Seminar (online, 2015)
  • GolfWorks Clubmaking AcademyFitting, Assembly & Repair School (2012)

Driver:  :touredge: EXS 10.5°, weights neutral   ||  FWs:  :callaway: Rogue 4W + 7W
Hybrid:  :callaway: Big Bertha B16 OS 4H at 22°  ||  Irons:  :callaway: Mavrik MAX 5i-PW
Wedges:  :callaway: MD3: 48°, 54°... MD4: 58° ||  Putter:  image.png.0d90925b4c768ce7c125b16f98313e0d.png Inertial NM SL-583F, 34"  
Ball:  :srixon: QStar Tour - Divide  ||  Bag: :sunmountain: Three 5 stand bag

Awards, Achievements, and Accolades

Note: This thread is 5418 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Want to join this community?

    We'd love to have you!

    Sign Up
  • TST Partners

    Carl's Place
    PlayBetter
    Golfer's Journal
    ShotScope
    The Stack System
    FitForGolf
    FlightScope Mevo

    Coupon Codes (save 10-20%): "IACAS" for Mevo/Stack/FitForGolf, "IACASPLUS" for Mevo+/Pro Package, and "THESANDTRAP" for ShotScope. 15% off TourStriker (no code).
  • Posts

    • I work with a lot of golfers who want more shaft lean at impact, who currently have AoAs that range from +2° to -2°, and who love to see the handle lower and more "in front of their trail thigh" from face-on at P6. And a lot of these golfers try to solve the issue by working on the downswing. They do something to drag the handle forward. Or they just leave their right thigh farther back so the same handle location "looks" farther forward. Or they move the ball back in their stance. Or they push themselves down into the ground to get the handle lower and increase (decrease?) their AoA (to be more negative). The real fix is often to get wider in the backswing. To do LESS in the backswing. To hinge less, fold the trail arm less, abduct the trail arm less. I had a case of this over the weekend. Before, the player had 110° of trail elbow bend, "lifted" his trail humerus only a few degrees, etc. The club traveled quite a bit around him, and he tended to "pick" the ball from the fairways. In the "after" swings below (which are mild exaggerations — this golfer does not need to end up at < 70° of elbow bend. These were slower backswings with "hit it as hard as you normally would" intent downswings), you can see that he bent his elbow about 70° instead of 110° and lifted his right arm an extra ~15° or more. You can't see how much less this moved his hands across his chest (right arm abduction), but it was also decreased. His hands stayed more "in front of" his right shoulder rather than traveling "beside" them so much. The two swings look like this: The change at P6, without talking about the downswing one little bit (outside of him telling me that he tends to pick the ball), is remarkable: Without 110° of elbow bend to get out (which he gets to 80°, a loss of 30°), the golfer actually loses slightly less elbow bend (70 - 50 = 20), but delivers 30° less elbow bend, lowering the handle and letting the elbow get "in front of" the rib cage… because it never got "behind" or "beside" the rib cage. If you look at this video showing the before/afters of P6, you'll note the handle location (both vertically and horizontally) and the shoulders (the ball is in the same place in these frames). This golfer's path was largely unaffected (still pretty straight into the ball, < 3° path and often < 1.5°), but his AoA jumped to -5° ± 2°. I've always said, and in talking with other instructors they agree and feel similarly, that we spend a lot of time working on the backswing. This is another example of why.
    • We had a member of our senior club who developed a mental block on pulling the trigger. I played with him to see what the membership was talking about. I timed him a few times when he would get over the ball. 45 seconds. He knew he had a mental block and would chide himself, “Just hit it!” Once on the green he was okay and chipping was a bit better. It was painful to watch him struggle. Our “bandaid” was to put him in the last tournament  tee time with two understanding players. We should have suggested to him to take a break from our tournaments. I agree with the idea that when a player realizes they have a problem, the answer is to go fix it and not return until they are able to play at an acceptable pace.
    • Day 56 (4 May 26) - Worked on some ball-then-ground drills - going from P3 thru impact - with a slowed tempo, working to keep all parts in sync.   
    • Wordle 1,780 3/6 🟩⬜🟨🟨🟨 ⬜⬜⬜⬜⬜ 🟩🟩🟩🟩🟩
    • Wordle 1,780 4/6 🟨⬜⬜⬜🟨 ⬜🟨🟨🟨⬜ 🟩🟨🟩🟨⬜ 🟩🟩🟩🟩🟩
×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.