Advice on Cutting Down 3 & 5 Woods

[MikeLowry5]

With so much success with cutting some off my Driver shaft I am thinking of shortening the 3 wood and 5 woods. Both are the 07 Burners, already have the lighter shaft so I wouldn't want to take too much off of them. Currently I hit both clubs fairly well however I feel that if we take just a bit off (3/4" or so) the accuracy will be that much better.

[CrazyXGolfer]

I would sugest cutting down one or the other. For me I actully cut down my 5 wood so I can hit it out of bad lies ect. I have never cut down my driver or 5 wood, but I did this just for a test and live it. I also do have a hybrid though with the 1/2 inch over size shaft on it for the course's with little rough and great tight fairways.

[GJac10]

With so much success with cutting some off my Driver shaft I am thinking of shortening the 3 wood and 5 woods. Both are the 07 Burners, already have the lighter shaft so I wouldn't want to take too much off of them. Currently I hit both clubs fairly well however I feel that if we take just a bit off (3/4" or so) the accuracy will be that much better.

why not just choke down on the club so that you don't lose any torque?

[ajschn06]

I like my set to flow, so when I cut down my driver I had to cut my 3 wood and 5 wood to match it. I cut the 3 1/2" shorter than the driver and the 5 1/2" shorter than the 3 wood...

[Titleist_ProV1x]

With so much success with cutting some off my Driver shaft I am thinking of shortening the 3 wood and 5 woods. Both are the 07 Burners, already have the lighter shaft so I wouldn't want to take too much off of them. Currently I hit both clubs fairly well however I feel that if we take just a bit off (3/4" or so) the accuracy will be that much better.

3/4s is a lot, you should try 1/2 first