Jump to content
Check out the Spin Axis Podcast! ×
Note: This thread is 4967 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

Posted

Just picked up my new Wilson Staff Ci6 irons and hit them for the first time.

Since i have a real set of irons now, what does everyone use to clean the face and bottom of their clubs?

Also, is there any polish that can be used for the bottom or is soap and water a general remedy?

DRIVER:  R5

3 WOOD: Burner

IRONS: RAC OS2

WEDGE:  60* Tour Wedge


Posted

I use a wet towel during a round, but once every couple weeks I will pull them all out and give them a good cleaning.

Here's my routine:

Fill up the sink with a couple inches of dish soap and water mix.

Dip the head of the club into the soapy water and then scrub the grooves with a cleaning brush.

Use a soapy rag to clean the rest of the club and shaft.

Rinse it off and then dry them.

Once I've done all the clubs, I'll change the soap and water out and then use a generic scrub brush and scrub each grip down and then use a rag with soap and water to wipe them down really well.  Then rinse them really well and set them aside overnight to dry.

I've been doing this for 2 years and never had a single problem.


Posted

Originally Posted by Bullitt5339

I use a wet towel during a round, but once every couple weeks I will pull them all out and give them a good cleaning.

Here's my routine:

Fill up the sink with a couple inches of dish soap and water mix.

Dip the head of the club into the soapy water and then scrub the grooves with a cleaning brush.

Use a soapy rag to clean the rest of the club and shaft.

Rinse it off and then dry them.

Once I've done all the clubs, I'll change the soap and water out and then use a generic scrub brush and scrub each grip down and then use a rag with soap and water to wipe them down really well.  Then rinse them really well and set them aside overnight to dry.

I've been doing this for 2 years and never had a single problem.


I assume you've never had any rust because everything is stainless?

I cleaned mine tonight with a wet rag and it worked well getting the grass out of the grooves. I've also go Golf Pride grips so I'll need to make sure they stay clean and tacky too.

Thanks for the reply.

Any other methods anyone?

DRIVER:  R5

3 WOOD: Burner

IRONS: RAC OS2

WEDGE:  60* Tour Wedge


Posted

Originally Posted by Bullitt5339

My clubs are forged steel, so they can rust, but I just make sure I dry them off real well and have never had any rust.

Didnt think about that. I'm using stainless cavities. So, I guess I don't need to worry at all about rust really.

DRIVER:  R5

3 WOOD: Burner

IRONS: RAC OS2

WEDGE:  60* Tour Wedge


Posted

i clean mine after every round and sharpen teh groove every 3 rounds or so

:tmade: Driver: TM Superfast 2.0 - 9.5degree - Reg flex
:mizuno: 3 Wood: JPX800 - 16* Exhsar5 Stiff
:mizuno: 3 - PW: MP-67 Cut Muscle back - S300 stiff
:slazenger: Sand Wedge: 54degree, 12degree bounce
:slazenger: Lob Wedge: 60degree 10degree bounce
:ping: Putter: Karsten 1959 Anser 2 Toe weighted
:mizuno: Bag - Cart Style


Posted
I clean the club with a moist/dry towel after every shot, never use groove sharpener.

Ogio Grom | Callaway X Hot Pro | Callaway X-Utility 3i | Mizuno MX-700 23º | Titleist Vokey SM 52.08, 58.12 | Mizuno MX-700 15º | Titleist 910 D2 9,5º | Scotty Cameron Newport 2 | Titleist Pro V1x and Taylormade Penta | Leupold GX-1

Awards, Achievements, and Accolades

Posted

so really the only "cleaner" really should be water and mild dish soap is what I'm taking from this.

DRIVER:  R5

3 WOOD: Burner

IRONS: RAC OS2

WEDGE:  60* Tour Wedge


Posted
so really the only "cleaner" really should be water and mild dish soap is what I'm taking from this.

I've never experienced dirt on the clubs that clean water and a towel can't remove. Sometimes use a tee or soft brush to clean out the grooves.

Ogio Grom | Callaway X Hot Pro | Callaway X-Utility 3i | Mizuno MX-700 23º | Titleist Vokey SM 52.08, 58.12 | Mizuno MX-700 15º | Titleist 910 D2 9,5º | Scotty Cameron Newport 2 | Titleist Pro V1x and Taylormade Penta | Leupold GX-1

Awards, Achievements, and Accolades

Posted

I just cleaned my irons 2 weeks ago. I added basic car wash soap into a 5-gal bucket & filled it halfway with water. Let the irons stand in the soapy water for 5 minutes. After the soapy water soak I scrubbed each club head with a plastic bristled brush...dirt & grime fell right off. Rinsed each with the hose, toweled off & set aside in the sun to dry.

Once the irons were cleaned used the (now damp) towel to wipe down hybrids.


Posted

A trickle of water out the faucet and a nylon brush is all I've ever needed.  A few seconds scrubbing and then dry off the club head and it's done.  I use a wet towel on the course after each shot though so there's rarely much to clean later on.

Brad


Posted

Originally Posted by Zeph

I clean the club with a moist/dry towel after every shot, never use groove sharpener.

Yep.  I was taught as a young caddie (a loooong time ago) to carry a large bath type towel that's half wet/half dry.  Takes care of the ball on the green too.

If I'm bored, I'll run a tee or my divot repair tool through the grooves during a round......but I'm not that bored very often.

I've never cleaned a club more than that.

In David's bag....

Driver: Titleist 910 D-3;  9.5* Diamana Kai'li
3-Wood: Titleist 910F;  15* Diamana Kai'li
Hybrids: Titleist 910H 19* and 21* Diamana Kai'li
Irons: Titleist 695cb 5-Pw

Wedges: Scratch 51-11 TNC grind, Vokey SM-5's;  56-14 F grind and 60-11 K grind
Putter: Scotty Cameron Kombi S
Ball: ProV1

Awards, Achievements, and Accolades

Posted

I wipe them down during the round and about once a week or so I clean them up good... I have a bucket that I fill with warm water and dish soap and I put the clubs in there and then scrub them down, then I dip the brush in the soapy water and scrub down the grip.  After that, I dry them off with a towel and repeat.

Tristan Hilton

My Equipment: 
Titleist TSR2 Driver (Fujikura Pro 2.0 TS; 10.5°) · PXG 0211 FWs (Diamana S+ 60; 15° and 21°) · PXG 0211 Hybrid (MMT 80; 22°) · Edel SMS Irons (SteelFiber i95; 5-GW) · Edel SMS Pro Wedges (SteelFiber i110; 56°, 60°) · Edel Classic Blade Putter (32") · Maxfli Tour Ball · Pinned Prism Rangefinder · SuperStroke Grips · Flightscope Mevo · TRUE Linkswear Shoes · Vessel Player V Pro 

Awards, Achievements, and Accolades

Posted

thanks for all the input everyone, i appreciate it. i just want to take care of these as they are my first real set of clubs.

thanks everyone

DRIVER:  R5

3 WOOD: Burner

IRONS: RAC OS2

WEDGE:  60* Tour Wedge


Posted

Like the other guys I use the bathroom sink, soap and water. I learned the hard way about getting the water too hot as the glue softens or the steel expands and things get loose. Luke warm cuts the grime and I can let the soak a little bit without worry..


Posted

i wouldn't overthink it, water, brush (old toothbrush works great), towel, dish soap if you feel like it....

Make sure you dry them well....


Note: This thread is 4967 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Want to join this community?

    We'd love to have you!

    Sign Up
  • TST Partners

    PlayBetter
    Golfer's Journal
    ShotScope
    The Stack System
    FitForGolf
    FlightScope Mevo
    Direct: Mevo, Mevo+, and Pro Package.

    Coupon Codes (save 10-20%): "IACAS" for Mevo/Stack/FitForGolf, "IACASPLUS" for Mevo+/Pro Package, and "THESANDTRAP" for ShotScope. 15% off TourStriker (no code).
  • Posts

    • Day 11: did mirror work for a while. Worked on the same stuff. 
    • I'm not sure you're calculating the number of strokes you would need to give correctly. The way I figure it, a 6.9 index golfer playing from tees that are rated 70.8/126 would have a course handicap of 6. A 20-index golfer playing from tees that are rated 64/106 would have a course handicap of 11. Therefore, based on the example above, assuming this is the same golf course and these index & slope numbers are based on the different tees, you should only have to give 5 strokes (or one stroke on the five most difficult holes if match play) not 6. Regardless, I get your point...the average golfer has no understanding of how the system works and trying to explain it to people, who haven't bothered to read the documentation provided by either the USGA or the R&A, is hopeless. In any case, I think the WHS as it currently is, does the best job possible of leveling the playing field and I think most golfers (obviously, based on the back & forth on this thread, not all golfers) at least comprehend that.   
    • Day 115 12-5 Skills work tonight. Mostly just trying to be more aware of the shaft and where it's at. Hit foam golf balls. 
    • Day 25 (5 Dec 25) - total rain day, worked on tempo and distance control.  
    • Yes it's true in a large sample like a tournament a bunch of 20 handicaps shouldn't get 13 strokes more than you. One of them will have a day and win. But two on one, the 7 handicap is going to cover those 13 strokes the vast majority of the time. 20 handicaps are shit players. With super high variance and a very asymmetrical distribution of scores. Yes they shoot 85 every once in a while. But they shoot 110 way more often. A 7 handicap's equivalent is shooting 74 every once in a while but... 86 way more often?
×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.