Jump to content
IGNORED

does Lighter swing weight = Loss in distance?


Note: This thread is 4618 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

I had my clubs shortened 1.5" from the butt end, and they feel a lot lighter to swing.  I also had them bent upright 2 degrees (not sure if that's the right combination of adjustments, shortened and upright)... but anyway I was wondering if I would technically lose any distance by shortening them and not fixing the swingweight to where it was before.

The clubs I hit consistently now that I make better contact are...

PW = 125yd

9 iron = 140 yd

8 iron = 155 yd

these are all with 3/4 swings because I haven't been able to control a full swing yet.

Callaway FT-9 Tour 8.5* IMIX
Taylormade R9 3-wood 18* (neutral Position)
Callaway Fusion 3-PW, AW, SW, LW
Nike Method 002

Titleist DT Carry whenever possible

Last few rounds been playing Srixon Soft Feel 2-piece

Link to comment
Share on other sites


If it is too low of a swing weight for your swing speed you can lose the ability to control the clubhead which would result in a loss of distance. Our local golf pro and I are currently experimenting with shortening our 3 and 4 iron to match the length of the 6 iron to help gain a little bit of control but he was being very careful in checking the swing weight to make sure it didn't go down enough to effect being able to control the club. It is mainly on the back swing, if the swing weight goes too low and you have a fast back swing it can cause some issues. Try a full swing and slow down your backswing.

Link to comment
Share on other sites

Awards, Achievements, and Accolades

You will definitely hit the club shorter by lopping off that 1.5". You did drop about 9 sw points. Throw some winn lite grips on there and that will probably get 6 sw points back depending on what grips were on there before.

Originally Posted by itching4scratch

I had my clubs shortened 1.5" from the butt end, and they feel a lot lighter to swing.  I also had them bent upright 2 degrees (not sure if that's the right combination of adjustments, shortened and upright)... but anyway I was wondering if I would technically lose any distance by shortening them and not fixing the swingweight to where it was before.

The clubs I hit consistently now that I make better contact are...

PW = 125yd

9 iron = 140 yd

8 iron = 155 yd

these are all with 3/4 swings because I haven't been able to control a full swing yet.



Link to comment
Share on other sites


You will definitely hit the club shorter by lopping off that 1.5". You did drop about 9 sw points. Throw some winn lite grips on there and that will probably get 6 sw points back depending on what grips were on there before.

Can this be accomplished by adding to the club-head end instead, and if so, how much weight would he add?

-- Michael | My swing! 

"You think you're Jim Furyk. That's why your phone is never charged." - message from my mother

Driver:  Titleist 915D2.  4-wood:  Titleist 917F2.  Titleist TS2 19 degree hybrid.  Another hybrid in here too.  Irons 5-U, Ping G400.  Wedges negotiable (currently 54 degree Cleveland, 58 degree Titleist) Edel putter. 

Link to comment
Share on other sites

Awards, Achievements, and Accolades

Yes it could be accomplished by adding the the head instead. Approx 18gr of weight would be needed.

Originally Posted by Shindig

Can this be accomplished by adding to the club-head end instead, and if so, how much weight would he add?


Link to comment
Share on other sites


Quote:

You will definitely hit the club shorter by lopping off that 1.5". ...

For rough planning, 3 -to- 4* loft difference and 1/2 inch in shaft length between irons contributes to about 10 yds. difference in distance. The difference will be a little more or less depending on clubhead speed.

So, the 1.5" trimmed off could lead to a loss of roughly 15 yards for the average golfer. This shortens your swing arc.

A slight trim could improve distance for some persons if the adjustment increased the golfer's control, and number of solid hits.

Also to itching : A three-quarter swing gets it done for a lot of people. Watch the PGA pros on TV, lots of them will make three-quarter swings in tight situations to gain control. The announcers often mention this.

Focus, connect and follow through!

  • Completed KBS Education Seminar (online, 2015)
  • GolfWorks Clubmaking AcademyFitting, Assembly & Repair School (2012)

Driver:  :touredge: EXS 10.5°, weights neutral   ||  FWs:  :callaway: Rogue 4W + 7W
Hybrid:  :callaway: Big Bertha OS 4H at 22°  ||  Irons:  :callaway: Mavrik MAX 5i-PW
Wedges:  :callaway: MD3: 48°, 54°... MD4: 58° ||  Putter:image.png.b6c3447dddf0df25e482bf21abf775ae.pngInertial NM SL-583F, 34"  
Ball:  image.png.f0ca9194546a61407ba38502672e5ecf.png QStar Tour - Divide  ||  Bag: :sunmountain: Three 5 stand bag

Link to comment
Share on other sites

Awards, Achievements, and Accolades

  • 2 weeks later...

on the other hand, would adding weight to a normal swing weight add distance?

Callaway FT-9 Tour 8.5* IMIX
Taylormade R9 3-wood 18* (neutral Position)
Callaway Fusion 3-PW, AW, SW, LW
Nike Method 002

Titleist DT Carry whenever possible

Last few rounds been playing Srixon Soft Feel 2-piece

Link to comment
Share on other sites




Originally Posted by itching4scratch

on the other hand, would adding weight to a normal swing weight add distance?


All things being equal, maybe.  E= mv2--sorry can't properly type the exponent. If you mean will adding weight to the clubhead cause the ball to go further, if the weight is delivered at the same angle and with the same velocity, then more energy should be imparted to the ball and it should go further. It won't be because you changed the swingweight, but because you hit the ball with a heavier hammer.However, if you swing slower, you might actually lose distance as velocity is squared vs weight just increased.

Swingweight is a relative and static measurement. You can have a heavy club with a thick stiff shaft with a lower swingweight than a lighter overall club with a light shaft. Loft, length, and total weight have more effect on pure distance than swingweight, but consistent swingweight helps your feel of the club and proper delivery of clubface to ball from club to club.

In your experiment, as others have said, the most important factor in distance as I see is the shaft length. In pure physics, this should reduce arc and therefore velocity and therefore distance, but some of this might be offset if the shorter club gives you better control and your strike is purer.

Don

In the bag:

Driver: PING 410 Plus 9 degrees, Alta CB55 S  Fairway: Callaway Rogue 3W PX Even Flow Blue 6.0; Hybrid: Titleist 818H1 21* PX Even Flow Blue 6.0;  Irons: Titleist 718 AP1 5-W2(53*) Shafts- TT AMT Red S300 ; Wedges Vokey SM8 56-10D Putter: Scotty Cameron 2016 Newport 2.5  Ball: Titleist AVX or 2021 ProV1

Link to comment
Share on other sites

Awards, Achievements, and Accolades

Moe Norman who had deadly accurate but not known for super long distance (long enough to win)  weighted his entire club with lead, even under the grips.

His reasoning was a heavy club hits harder, and a harder hit goes further. - But, he's Moe Norman.

"Quick Dorthy....the oil can!"

Link to comment
Share on other sites


If you lose weight in the club, especially in the head it will be harder for you to know where the club is and could affect your timing and therefore lose distance

Link to comment
Share on other sites


Note: This thread is 4618 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Want to join this community?

    We'd love to have you!

    Sign Up
  • TST Partners

    TourStriker PlaneMate
    Golfer's Journal
    ShotScope
    The Stack System
    FlightScope Mevo
    Direct: Mevo, Mevo+, and Pro Package.

    Coupon Codes (save 10-15%): "IACAS" for Mevo/Stack, "IACASPLUS" for Mevo+/Pro Package, and "THESANDTRAP" for ShotScope.
  • Posts

    • Thanks for the feedback. @StuM, we are a "club without real estate" so no facilities or pro. We have a membership of around 185 players and we only play together as a group at our tournaments, which are held at public access courses. A group of us setup the tournaments, collect the money and dole out the prizes.
    • In general, granting free relief anywhere on the course isn't recommended.  Similarly, when marking GUR, the VSGA and MAPGA generally don't mark areas that are well away from the intended playing lines, no matter how poor the conditions.  If you hit it far enough offline, you don't necessarily deserve free relief.  And you don't have to damage clubs, take unplayable relief, take the stroke, and drop the ball in a better spot.
    • If it's not broken don't fix it. If you want to add grooves to it just because of looks that's your choice of course. Grooves are cut into putter faces to reduce skid, the roll faced putter is designed to do the same thing. I'm no expert but it seems counter productive to add grooves to the roll face. Maybe you can have it sand-blasted or something to clean up the face. Take a look at Tigers putter, its beat to hell but he still uses it.     
    • I get trying to limit relief to the fairway, but how many roots do you typically find in the fairway? Our local rule allows for relief from roots & rocks anywhere on the course (that is in play). My home course has quite a few 100 year old oaks that separate the fairways. Lift and move the ball no closer to the hole. None of us want to damage clubs.
    • Hello, I've been playing a Teardrop td17 F.C. putter for many years and love it. It still putts and feels as good or  better than any of the new putters I've tried and it's in excellent condition except the face has dings in it ever since I bought it used that kind of bother me. I was just wondering if it's possible to have some really shallow horizontal grooves milled into the face on a "roll face" putter. I think I would rather spend some money on it instead of trying to get used to a new putter.  Thanks
×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.

The popup will be closed in 10 seconds...