Trimming Rifle shafts (old Royal P. model, before TT purchase)

[pgone]

Take the 3 iron side to side, butt to butt, with pw ---make your mark--should be 3" . If not make the cut where your mark is.

[msmalls22]

13 minutes ago, pgone said:

Take the 3 iron side to side, butt to butt, with pw ---make your mark--should be 3" . If not make the cut where your mark is.

Okay but make the cut at the tip not from the butt and correct?

[pgone]

Tip trim for flex--butt trim for length. Sorry, I gotta take a nap...

[msmalls22]

On 7/28/2017 at 7:19 PM, pgone said:

Tip trim for flex--butt trim for length. Sorry, I gotta take a nap...

Sorry for all of the questions, it is very much appreciated.  I am getting them re-shafted today.  I just realized my irons have Memphis 10 shafts on them.  I have no idea how since these irons were released in 2014 and that shaft hasn't been around in quite awhile.

 

Either way thank you to *everyone* for all of the assistance!!!!

[msmalls22]

So the 3i is 4.25 inches longer than the PW shaft.

Should I trim it to match, or maybe 4.5 inches to make it a tad shorter than the PW?