Jump to content
Check out the Spin Axis Podcast! ×
Note: This thread is 5828 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Recommended Posts

Posted
I am 14, around 6 foot tall.

Is there any point getting custom fitted right now? Should I wait until I finish growing?

Would getting taller affect how upright/flat a lie I'd need?

My Clubs
Driver - LV4 10* R flex
Wood - sam snead persimmon 2 wood (for windy days)
Hybrid burner tour launch 20* stiff flex.
Irons - Tour Mode 3i,4i stiffIrons - FP's 5-PW R-flexWedge - spin milled 54.14Wedge - spin milled 60.07Putter - Victoria Lowest round 2010: 79 (par 70)Latest rounds at...


Posted
Well, that depends who your current irons are fit for. If they were good for you at 5'10, they aren't likely to be terrible for you at 6'. However, if they are off-the-rack 5'8", you might want to look into it.

While the right fit for your clubs is going to vary a bit in the next few years, you probably don't want to remain too far from it, for risk of picking up bad habits by compensation.

-- Michael | My swing! 

"You think you're Jim Furyk. That's why your phone is never charged." - message from my mother

Driver:  Titleist 915D2.  4-wood:  Titleist 917F2.  Titleist TS2 19 degree hybrid.  Tour Edge Exotics C723 21 degree hybrid.  Irons 5-U, Ping G400.  Wedges negotiable (currently 54 degree Cleveland, 58 degree Titleist) Edel putter. 

Awards, Achievements, and Accolades

Posted
I may offer a suggestion... Get some nicer clubs (forged) mainly because they bend so easily and as you grow, they can be readjusted... as you grow they can also be lengthened. if you get cast, they don't bend well and if you have to bend them +2 degrees, they are very brittle.

Anyway I would get fitted now, and again every 3 months as your body changes... consider it like somethign fun to do... it doesn't take long and you'll notice all the difference in the world!

909D2 - 10.5º
909 F2 3 wood15º
AP 2 3-PW PX 5.5
52º Black Nickle and 60º oil can Both Spin Milled
reg 588 56º White Ice Rossie Z Star Tour YELLOWSG3


Posted
Well it depends. Are your parents willing to pay for you to get fitted. If so then do it. If not, then wait a couple of years.

Tools of the Trade
Burner Driver. 9.5 Loft. Stiff Shaft

Pro CB Irons, 3-PW, Stiff Shaft
SV Tour Wedges: 52,56,60


Posted
It depends on whether or not you are still growing. If you are, there is no reason to, unless you can afford new irons every year. If you are done growing, then getting fit might help you.

In my bag:

Driver: Titleist TSi3 | 15º 3-Wood: Ping G410 | 17º 2-Hybrid: Ping G410 | 19º 3-Iron: TaylorMade GAPR Lo |4-PW Irons: Nike VR Pro Combo | 54º SW, 60º LW: Titleist Vokey SM8 | Putter: Odyssey Toulon Las Vegas H7

Awards, Achievements, and Accolades

Posted
I may offer a suggestion... Get some nicer clubs (forged) mainly because they bend so easily and as you grow, they can be readjusted... as you grow they can also be lengthened. if you get cast, they don't bend well and if you have to bend them +2 degrees, they are very brittle.

+1

Pick up a used set of forged irons that are more or less your specs and get them adjusted to fit you.
In the bag...

G10 9° Driver
G10 17° 4 Wood
G10 21° Hybrid i15 4-PW Tour-W Wedges 50/12 & 56/10 Scotty Cameron Studio Select Newport 2 (35")Balls - Bridgestone B330-RX

Posted
I am 14, around 6 foot tall.

Go the cheap way out. If there is a Ping fitting center near you, go there and play around with the different lies (color codes) and shafts. You could have different 10 players at 6' tall and they all might have different requirements. Im almost 6' 3" and play with the older Tourney irons that are considered to be about a 1/2" shorter by todays standards. I have them adjusted at 1 degree upright, and thats about it. I have XX-large glove type hands..... but prefer thinner grips. A fitting center would be a good idea. You could always incorporate what you learned into you current set of irons if you want to keep them. Your only 14 and already at 6 feet. I am betting that you may eventually need some adgustments, but nothing too crazy right now.

Posted
When you hit your irons, you'll see that the face will have dirt on the bottom half. If the line formed by the top of the dirt goes straight across, then the club is the right lie angle. If it is sloped, i.e. the dirt is much higher on one side, then you need a lie adjustment. It's a fairly easy way to tell, and it costs nothing.

Posted
thanks for all the advice.

I probably won't be buying new clubs for a few years anyway, I'll try out your tip shanks.

My Clubs
Driver - LV4 10* R flex
Wood - sam snead persimmon 2 wood (for windy days)
Hybrid burner tour launch 20* stiff flex.
Irons - Tour Mode 3i,4i stiffIrons - FP's 5-PW R-flexWedge - spin milled 54.14Wedge - spin milled 60.07Putter - Victoria Lowest round 2010: 79 (par 70)Latest rounds at...


Note: This thread is 5828 days old. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it's still relevant. If not, please start a new topic. Thank you!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Want to join this community?

    We'd love to have you!

    Sign Up
  • TST Partners

    Carl's Place
    PlayBetter
    Golfer's Journal
    ShotScope
    The Stack System
    FitForGolf
    FlightScope Mevo

    Coupon Codes (save 10-20%): "IACAS" for Mevo/Stack/FitForGolf, "IACASPLUS" for Mevo+/Pro Package, and "THESANDTRAP" for ShotScope. 15% off TourStriker (no code).
  • Posts

    • Wordle 1,781 3/6* ⬛⬛🟦🟦🟦 🟦⬛⬛🟦🟦 🟧🟧🟧🟧🟧
    • Day 36: back to some mirror work tonight. Need a bit more forearm roll in my feels to help with the shallowing. 
    • _sigh_ so close to red text.  Went away for three days, but didn't do a practice morning-of-departure (Friday) nor evening-of-return (Sunday), so I had three misses, back to day one. Day 1, May 4 2026.  At home today, spent nearly an hour in my practice room, hitting about three dozen practice balls, primarily with my 6-iron.
    • Day 254 5-4 Arms off chest in backswing and downswing. Short swing, pause and then hit.  Hit foam balls. Keeping arching of wrist a focus as well. 
    • I would think of it in terms of time. The time it takes to get the arm angle into a good position to deliver the club with proper shaft lean. Another component is rotation, but that is also a matter of timing. It relates to how the body stalls to give the golfer time to hit the ball. If you have to get 80+ degrees out of that right elbow in one third of a second versus 50 degrees in the same time then you have to steal time from somewhere. It is usually body rotation. That does not help with shaft lean.  I agree in that amateurs tend to make the swing more complicated than pro golfers. 
×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.