Jump to content
RFKFREAK

My Swing (RFKFREAK)

283 posts / 22004 viewsLast Reply

Recommended Posts

14 minutes ago, GolfLug said:

@RFKFREAK, take this with a grain of salt but if I were you I would set my right wrist almost immediately as the first thing off the ball before your left arm start moving away in the backswing. You will have a much easier time staying on plane and not lifting up your torso to finish out your backswing. And yes, it will feel wierd.  

I don't think I quite understand what you mean.  I feel that except for probably too much lower body movement, my backswing is actually pretty good.  I don't see much movement of my torso on the swings.  Are you saying it should be completely still?  I fear if I set my right wrist too quickly that I'll mess up the timing of the clubhead bisecting my hands at A2.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Want to hide this ad? Register for free today!

14 minutes ago, RFKFREAK said:

I fear if I set my right wrist too quickly that I'll mess up the timing of the clubhead bisecting my hands at A2.

You can still get clubhead to line up with your hands at A2. Just that it will happen little closer to the ground. A2 should be happen ideally before it gets to beltline anyway. Keep your arms closer to your chest till you get to A2. Don't let them get away so quickly.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

2 minutes ago, GolfLug said:

You can still get clubhead to line up with your hands at A2. Just that it will happen little closer to the ground. A2 should be happen ideally before it gets to beltline anyway. Keep your arms closer to your chest till you get to A2. Don't let them get away so quickly.

Ok, I'll give it a go, thanks!

Going to rain today so probably won't hit the range again until Saturday as I'm looking to play tomorrow. 

Edited by RFKFREAK

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

You're working on evolvr, so I won't say much here… but I do think that the right elbow folds and stays pretty tight to your body.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

2 minutes ago, iacas said:

You're working on evolvr, so I won't say much here… but I do think that the right elbow folds and stays pretty tight to your body.

Should I want my elbow away from my body?

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

18 minutes ago, RFKFREAK said:

Should I want my elbow away from my body?

Depends. More importantly is the over-flexing.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

1 minute ago, iacas said:

Depends. More importantly is the over-flexing.

Ok, thanks, I'll try and incorporate it with what my instructor has me working on (keeping lower body quiet from A1 to A2 and having the club raise quicker than my hands). 

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

5 minutes ago, RFKFREAK said:

Ok, thanks, I'll try and incorporate it with what my instructor has me working on (keeping lower body quiet from A1 to A2 and having the club raise quicker than my hands). 

That's why I didn't want to say too much. He'll get to that stuff in due time… for now, it's probably too much to worry about.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Just now, iacas said:

That's why I didn't want to say too much. He'll get to that stuff in due time… for now, it's probably too much to worry about.

Ok, sounds good.  I'll try it and if I feel it's too many pieces then I'll focus on what my instructor has me working on.

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Got a response from my instructor and he said one of the important things to work on was steepening the shaft from A2 to A4.  This is the last swing of the evening and although I think in the practice swings the shaft is steep enough, it flattens out in the actual swing.  I think I may have to do some mirror work before trying this at the range again.

 

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Super excited about the fact that I went to the range today and didn't slice my driver at all.  I feel like the mirror work definitely paid off as I have a better sense of what my arm angle has to look like to me on the backswing to get the shaft steep.  I think I did a better job of it.

 

 

Share this post


Link to post
Share on other sites
Awards, Achievements, and Accolades

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




  • Want to join this community?

    We'd love to have you!

    Sign Up
  • 2018 TST Partners

    PING Golf
    FlightScope Mevo
    More to come…
  • Posts

    • Well done, you should go to the 85+ one next year.
    • Yep. https://www.mgagolf.org/sites/default/files/Rules Quiz Answers 3-19_0.pdf Quite a poor job by my association.
    • The point is there really is a minimal amount that can be done to ‘prevent’ back issues that many if not most people experience simply by being humans. The golf swing is one of many, many reasons one can develop issues. And some people are more prone to problems than others. The golfers on tour who haven’t had problems don’t have a secret. They don’t have better posture. They’re simply luckier. Obviously certain movements can aggravate or accelerate back issues. But again people will progress at different time frames. Yes it’s nice to hear biomechanics/spine experts. I agree. But unless it’s a matter of extremely poor posture there isn’t a lot that can be done to make the golf swing ‘easier’ on the spine aside from an essentially ineffective swing. Just my 2 cents.
    • I'm new to metal-analysis and newish to golf and I'm sorry if this was s stupid question, like if these irons are somehow clearly cast, to the introductory-trained eye (like by looking at the writing formed into it rather than stamped), but I was confused because the metal seemed to have that same, stretchy-looking grain like the forged Haigs I have... (?) I did try looking up the answer but cannot find it anywhere. I suppose I'd guess "cast" if I had to for these irons, because of the way the logo looks, and because there are more premium versions/sets of Citations? I should probably preface most emails with the fact that I'm particularly into vintage things more than my score in some games (although I do have a relatively modern set for other occasions). I love my Northwestern irons, though, for example. When I get a good shot they are amazing to me. God as my witness, you have my word I'm not just crowd-sourcing y'all in a petty way trying to sell these irons or anything I post online or something, trying to get easy specs from you guys because I'm a seller. I do not sell golf equipment. I used to R&D and make archery equipment out of wood and composites. I just really, really like vintage things and have storage space and like to plan for the future, whether I pass them on over time to someone special or keep them (and knowing more about them helps). I dig before I ask. These came with, not persimmon, but unreal-feeling laminate woods I unexpectedly fell in love with and bought some softer balls for. While persimmon was and is a higher-brow thing, and while my Northwestern laminates feel crummy (love the NW irons tho), the Powerbilt laminate woods that came with this set are more rewarding to hit than some of my more modern steel ones from the late 90's and early 2000's. They have a thick metal sole and a hefty metal weight at the back, and I'd think would give some pure persimmon woods a run for their money. I also feel like it's less likely for the laminated Citation woods to form a crack in the hosel than aged, solid persimmon, and that comes from not only seeing lots of cracks in woods, but because -- even though I'm newer to golf, I am not new at all to hand-making performance sporting goods that put up with immense stress (bows and arrows).  At first I was disappointed when I showed up with $50 for this set of Citation irons with 4 woods, because I thought surely the 3 Citation woods were solid persimmon, but to my surprise they weren't (the picture deceived me). But after swinging these relatively highly engineered, latter-day laminate PB Citation woods, on my property, I am really glad I bought them anyway and intend on restoring them (some moisture got under the finish and tarnished them, and I am experienced in finishing and re-finishing archery equipment...usually by using epoxy clear coat that cures best at 105-115F or so, always superior to cold-cure urethanes and so forth in archery, way more scratch and gouge and ding-resistant, but I'll do a golf-spin on my R&D... while they were R&D'd plenty leading up until their day, there's always room for experimentation in customizing the way we refinish well-aged sporting goods after they become old, which they weren't when they were made.   🙂  Maybe heat-cured archery bow epoxy will be too hard and crack more than a cold-cure acrylic or urethane etc., but I bought a handful of cheap laminate woods nobody wanted to experiment with re: refurbishing coatings. If I can re-strengthen old, dried-out wood while I refurbish how it looks, I'd rather do it than just stay true to the original materials (esp. since I'd either keep them or gift them to friends instead of claiming a purist restoration). But I digress regarding my question about these irons. I'm thinking people are passing the thread by thinking I shouldn't bother people with the question until I can better identify obvious things? I did try looking it up, but the records I find are too ambiguous and do not delve into the differences between Citation, Citation Levelume (which people advertize as forged and which are even more commonly sold), etc. Thanks, Jeff
    • Actually, at first I thought the same thing, but it turns out there was another video on that page that auto-played along with the main video.  There wasn't any background music in the main video.  
  • TST Blog Entries

  • Blog Entries

  • Today's Birthdays


×
×
  • Create New...

Important Information

Welcome to TST! Signing up is free, and you'll see fewer ads and can talk with fellow golf enthusiasts! By using TST, you agree to our Terms of Use, our Privacy Policy, and our Guidelines.

The popup will be closed in 10 seconds...